OBD Code P0400

Exhaust Gas Recirculation Flow

What’s mean?

OBD2 Code P0400 Definition:
The exhaust gas recirculation (EGR) valve is vacuum controlled valve that regulates the amount of exhaust gases that re-enter the cylinders. The powertrain control module (PCM) determines how much based on engine load, temp, and other conditions. If the PCM detects that the amount of exhaust gases entering the cylinder were insufficient or non-existent, this code is set.

Symptoms

Possible sumptoms of P0400
No symptoms will likely be noticed by the driver other than the MIL (malfunction indicator lamp). However, non visible symptoms will be increased combustion temperature and increased Nox emissions. Sometimes you may notice a flat spot, or the vehicle may enter limp mode or show a EML light.

Possible Causes

Possible causes of P0400
A code P0400 may mean that one or more of the following has happened: Plugged EGR passage which restricts the flow of exhaust gasses Faulty EGR solenoid Faulty EGR solenoid wiring/harness Vacuum lines damaged/disconnected to the EGR valve solenoid or to the EGR valve Faulty EGR valve

Possible Solutions

Since EGR valve designs are different, no one test will suffice: Using a scan tool, operate the EGR valve with the engine running. If the engine stumbles, the problem was likely intermittent wiring problem or intermittent blockage problem If engine doesn’t stumble, operate the EGR valve manually, if possible. If engine doesn’t stumble and die, the ports are likely plugged. Removal of valve and cleaning of all ports will be required Checking of solenoid can only usually be done with a scan tool, because most solenoids operate with a duty cycle of voltage, rather than constant voltage Check all vacuum lines, hoses, etc for any damage Visually inspect the solenoid harness and the solenoid for damage Replace EGR valve

OBD-II Codes

P0401 P0402 P0403